Munters - Dehumidification / Humidification / Cooling. Munters Desiccant Rotor Technology. Munters desiccant dehumidifiers attract moisture from the air by creating an area of low vapour pressure at the surface of the desiccant. The pressure exerted by the water in the air is higher, so the water molecules move from the air to the desiccant and the air is dehumidified. Munters desiccant dehumidifiers make use of changing vapour pressures to dry air continuously in a repeating cycle described by the simple diagram below. Another type of heat exchanger is the plate heat exchanger. These exchangers are composed of many thin, slightly separated plates that have very large surface areas and small fluid flow passages for heat transfer. Advances in gasket and brazing technology have. International Journal of Engineering Research and Applications (IJERA) is an open access online peer reviewed international journal that publishes research. Paper submitted to IJERA : 927 Accepted papers by peer review process : 335 Rejected Paper : 592. As the desiccant picks up moisture from the surrounding air, dry air is discharged to the process area and the reactivation air stream discharges the wet air outside. Munters units can operate in a wide range of temperatures, including at low temperatures down to - 4. Power. Purge saves energy in two ways. The unique patented Power. Purge acts as an energy recovery system, collecting waste heat off of the hottest section of the desiccant wheel and using it to help with the regeneration by pre- heating the coolest part of the rotor. This reduces the energy required for reactivation while also reducing the discharge temperature of the process air, resulting in lower energy costs for post- cooling. Power. Purge can also save on first cost. Equipping a desiccant system with Power. Purge can reduce the size of the desiccant rotor without diminishing the dehumidification capacity. Benefits of Munters Power. Purge. A distribution pad on the top of the cooling pad ensures an even water distribution. The water flows down the corrugated surface of the GLASdek evaporative cooling pad. Part of the water is evaporated by the warm and dry air that passes through the pad. The heat that is needed for the evaporation is taken from the air itself. The air that leaves the pad is therefore cooled and humidified simultaneously without any external energy supply for the evaporation process. This is nature’s own cooling process. Modular design fits all AHUs. For airflows from 0. Munters award winning Oasis.
ECONOMIZER - A series of tubes located in the path of flue gases. Feedwater is pumped through these tubes on its way to the boiler in order to absorb waste heat from the flue gas. EDDY CURRENT TESTING - An electromagnetic nondestructive testing method in.An absorption refrigerator is a refrigerator that uses a heat source (e.g., solar energy, a fossil-fueled flame, waste heat from factories, or district heating systems) to provide the energy needed to drive the cooling process. Absorption refrigerators are often used for.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2017
Categories |